<< To start
<< Go back
Tech articles.
  • Clutch filing  2004-01-03
    Fixing the dragging or slipping clutch!

  • KTM/Penton -69 restoration  2002-10-19
    This article shows the restoration of the engine, shocks, fork and chassis. Paint job and everything else too. be welcomed.

  • Forged VS. Cast pistons  2002-09-12
    My local shop says something, the mags something else. Which piston should I go for ?

  • Premix oil guidance  2002-09-10
    Which oil should I use? Syntetic or mineral ? How much oil should I use ?

  • Mushy and week front break  2002-09-10
    Why won't my bike stop effectively, The pads are not too worn, the disk seems fine and the caliper works as far as I can see.

  • Wheel bearings  2002-09-09
    All about service, inspection and changing wheel bearings. Also general info about bearing codes etc.

Accosato
AJS
Alfer
Ancillotti
Aprilia
Vertemati
Ariel
ATK
Beta
BMW
BSA
Bultaco
Cagiva
Can-Am
Cannondale
CCM
CZ
Derbi
DKW
D-Rad
Fanatic
FN
Gas Gas
Gilera
Harley Davidson
Hedlund
Hercules
Hodaka
Honda
Horex
Husaberg
Husqvarna
IMZ
IZh
Indian
Jawa
Kawasaki
Kramit
KTM
L
Lem
Matchless
Maico/MStar
Malaguti
Montesa
Norton
NSU
Ossa
PMZ
Praga
Puch
Sokol
Suzuki
SWM
Standard
TIZ
TM
Triumph
Velocette
Victoria
VOR
Yamaha
Zündapp
Nauder
Rokon
Mazzilli
Dalesman
Sachs
Rotax
Hiro
TGM
Benelli
Rickman
Cooper
Monark
Penton
Lito


Aha
2002 © All right reserved. The information and tips that can be found on this web site may be used at your own risk, we don't accept any responsability for injuries or damage caused by following the instructions or information published here within. Always wear appropriate protection gear while riding. Keep the environmental damage and noise level down. Always ride where the risk of bothering wild life and other people is neglectable.
www.mxbikes.com, B Hahn